CAUTION: READ AND FOLLOW ALL SAFETY GUIDELINES AND WARNINGS BEFORE HANDLING OR
ATTEMPTING ANY WORK ON YOUR FIELD ONE PAINTBALL MARKER. SHOULD YOU BE UNSURE AT ANY
POINT, STOP AND GET HELP FROM A FIELD ONE PAINTBALL CERTIFIED TECHNICIAN.
BATTERY - The Force is capable of running on two AA batteries in the fore grip or one Field One LiPo rechargeable battery
(optional) located in the grip frame. In order to switch between the two power sources use the toggle switch inside the grip
frame on the main-board (fig 2) (access this area by removing the grip panel on the right hand side of the marker). The “UP”
position will engage the AAs and the “DOWN” position will engage the rechargeable LiPo battery. To change the AA batteries
use a 1/8 inch allen wrench to open the battery door in the bottom of the fore grip (fig 3). Turn the battery door release
screw clockwise 1/4 turn to release the door (this screw is not threaded). Once you have opened the battery door
remove the old batteries and install the new AAs in the direction shown on the inside of the battery door (fig 4). Once the
batteries are inserted press the battery door in with the F1 logo towards the front of the marker until it locks in place (fig 5).
Changing Batteries and Power Select
1. Unlock board to allow
adjustability of settings
2. Select Power
source.
3. Open battery door
with 1/8 allen wrench.
4. Change batteries.
5. Push battery door
back in until it locks
in place.
To Next Page
Loading...