COMMAND WORKSTATION 13
Fiery SeeQuence Suite
Fiery SeeQuence Impose and Fiery SeeQuence Compose may either be standard or offered as
options. This is dependent on the configuration of your E100.
Installing Command WorkStation
Install Command WorkStation on a Windows or Mac OS computer with a network
connection to the E100. For a complete list of system requirements, see Welcome.
The installer for Command WorkStation is provided on the User Software DVD as part of
the Fiery User Software Installer (Windows) or as a separate application (Mac OS). To install
Command WorkStation, see “Installing User Software” on page 7.
Configuring the connection to the E100
The first time you start Command WorkStation, you are prompted to configure the
connection to the E100. You can also edit the configuration whenever there is any change to
your E100 or network, such as a changed server name or IP address. If you change E100
Setup information, do so before you reconfigure the connection.
BEFORE YOU BEGIN
• Print the E100 Configuration page.
For instructions on printing the Configuration page, see Configuration and Setup on the User
Documentation CD.
The E100 Configuration page contains information you need when configuring the
connection, such as the IP address of the E100. For TCP/IP installations, you can use the
DNS name instead of the IP address. Make sure that the E100 is registered in a Domain
Name Server (DNS) on your network. For more information, contact your network
administrator.
To Next Page
Loading...
