Fife CDP-01 - User Manual

05-19-06 CDP-01 Figure Sheet 1-900
© 2006 Fife Corporation. All rights reserved.
CDP-01
Additional Instruction Manual
For Armless Recoiler Application
With Staggerwind (Variable Ratio)
Using SE-21A Sensor And SBPC (MS: 100333)

Fife CDP-01 Specifications

General

Brand	Fife
Model	CDP-01
Category	Controller
Language	English

Summary

GENERAL INTRODUCTION

Application Description

Explains the Armless Recoiler application using CDP-01, SE-21A sensor, and SBPC.

Software Part Numbers

Locates software part numbers on the CDP-01 housing for inquiries.

Connecting the System Components

Refers to the Cable Connection Diagram for system component connection.

OVERVIEW OF FUNCTION - CONTROL OPTIONS

Operator Control Options

Describes internal and external operation control methods for the CDP-01.

Special Features of External Control

Explains how external control disables CDP-01 keys and defaults to Manual mode if disconnected.

OVERVIEW OF FUNCTION - INPUT AND NETWORK TRAFFIC

Input Matrix - External Control (X7)

Details the mapping of external control inputs to CDP-01 functions.

Network Traffic Data Mapping

Shows data mapping from Network to FifeNet and FifeNet to Network.

OVERVIEW OF FUNCTION - OPERATING MODES (OSCILLATOR & MANUAL)

Oscillator and Manual Modes

Explains the 'Oscillator On/Off' and 'Manual' operating modes.

OVERVIEW OF FUNCTION - AUTOMATIC OPERATING MODE

Automatic Mode

Explains the 'Automatic' operating mode and sensor/mandrel behavior.

OVERVIEW OF FUNCTION - OTHER OPERATING MODES

Retract and Jog Modes

Explains 'Retract Sensor / Center Mandrel', 'Center Mandrel Only', 'Retract Sensor Only', 'Jog Mandrel', and 'Jog Sensor' modes.

START-UP CALIBRATION - POSITION TRANSDUCER

START-UP CALIBRATION - SENSOR BANDWIDTH TO MANDREL RATIO

START-UP CALIBRATION - GUIDING SENSOR (GUIDE CHANNEL)

START-UP CALIBRATION - GUIDING SENSOR (REFERENCE CHANNEL)

START-UP POLARITY - SENSOR

Sensor Servo-Center Polarity

Explains how to set the sensor servo-center polarity.

Sensor Automatic Polarity

Explains how to set the sensor automatic polarity.

START-UP POLARITY - MANDREL

Servo-Center Polarity

Explains how to set the mandrel servo-center polarity.

Guide Polarity

Explains how to set the mandrel guide polarity.

TROUBLESHOOTING

Fault Diagnosis - Fault Rectification

Describes common faults and their rectification procedures.