Fife CDP-01 - Default Chapter; Table of Contents

To Next Page

To Previous Page

SUPPLEMENTARY OPERATING MANUAL iii

TABLE OF CONTENTS

GENERAL INTRODUCTION 1

APPLICATION DESCRIPTION............................................................................................1-1

SOFTWARE PART NUMBERS ...........................................................................................1-1

CONNECTING THE SYSTEM COMPONENTS ..................................................................1-1

OVERVIEW OF FUNCTION 2

OPERATOR CONTROL OPTIONS .....................................................................................2-1

SPECIAL FEATURES OF EXTERNAL CONTROL .............................................................2-1

INPUT MATRIX - EXTERNAL CONTROL...........................................................................2-2

NETWORK TRAFFIC ..........................................................................................................2-2

EXPLANATION OF THE OPERATING MODES........................................................2-3 to 2-5

START UP / POSITION TRANSDUCER CALIBRATION ..........................................2-6 to 2-7

START UP / SENSOR BANDWIDTH TO MANDREL RATIO CALIBRATION .....................2-8

START UP / GUIDING SENSOR CALIBRATION (GUIDE CHANNEL) ...............................2-9

START UP / GUIDING SENSOR CALIBRATION (REFERENCE CHANNEL)...................2-10

START UP / SENSOR DRIVE POLARITY ........................................................................2-11

START UP / MANDREL DRIVE POLARITY......................................................................2-12

TROUBLESHOOTING 3

FAULT DIAGNOSIS - FAULT RECTIFICATION..................................................................3-1

05-19-06 CDP-01 Figure Sheet 1-900