Fiio Q5s - Side Indicator for Battery and Charging; Front Indicator for Sampling Rates

mode after you turn the device on next time.
b. The side indicator can also display the battery and charging status:
Hold the "Switch" button for about 3 seconds, the side indicator will light up and show the battery
status as follows:
<10%
10%-24%
25%-49%
50%-74%
75%-100%
○
○
○
©
○
○
○
●
○
○
●
●
○
●
●
●
●
●
●
●
Icon explained: ○- No light ●-Blue light ©-Red light
Low battery warning: When the battery is less than 10%, the side Coaxial input indicator will flash
red twice every 3 seconds to remind you that the device needs to be recharged.
When charging, the side indicator will show the charging status as follows:
Icon explained: ○- No light ●-Blue light ◎-Blue light flashes
The indicator will not indicate the current input mode when charging, but you can press the
"Switch" button briefly to check the input mode; at this time, you can switch the input mode by
pressing the "Switch" button within 5 seconds, if not, the indicator will go back to charging status.
c. The front indicator is to display the sampling rates of different input mode and Bluetooth status.
USB input: Blue (for sampling rates≤48kHz ); Yellow (for sampling rates>48kHz); Green (for DSD
tracks)
Line input: Sampling rates are not available and the Blue light stays steadily on
Optical/Coaxial inputs: Blue (for sampling rates≤48kHz ); Yellow (for sampling rates>48kHz)
Bluetooth status display will be specified in the Bluetooth mode part.
<25%
25%-49%
50%-74%
75%-99%
Charging completed
○
○
○
◎
○
○
◎
●
○
◎
●
●
◎
●
●
●
●
●
●
●