How to silence Fike Fire Alarms when it's not working?
If the Fike Fire Alarms system alarms cannot be silenced, ensure the panel is in Access Level 1 (User) or Access Level 2 (Supervisor). Refer to the operation section for instructions on entering the appropriate access level.
What to do if I am unable to reset the Fike Fire Alarms system?
If the Fike Fire Alarms system cannot be reset, first ensure that all alarms are silenced. If the alarms are not silenced, silence them before attempting to reset the system. Also, ensure that the panel is in Access Level 1 (User) or Access Level 2 (Supervisor). Finally, check for and remove any existing alarm conditions, for example, reset the call point element with a key.
What to do if the Fike Fire Alarms panel buzzer sounds and the POWER FAULT LED is flashing?
If the panel buzzer is sounding and the POWER FAULT LED is flashing, with ‘Mains supply failed’ displayed on your Fike Fire Alarms system, this indicates a mains supply failure. Wait for the mains supply to be restored. If the panel does not return to normal operation after the power is restored, contact an engineer.
What does it mean when the Fike Fire Alarms panel buzzer is sounding and the SYSTEM FAULT LED is lit?
If the panel buzzer is sounding and the SYSTEM FAULT LED is lit on your Fike Fire Alarms system, this indicates a control panel fault. You should call an engineer immediately.
General| Brand | Fike |
|---|---|
| Model | CIE-A-200 |
| Category | Control Panel |
| Language | English |
To Next Page
