5. LCD Controller Display
1.
2. Press ＂M＂to choose the mode
Press "M"again cooling
Press "M"again heating
3. Standby status:
Press "M" 5 seconds,get a sound “B” ,LCD display will show “0" “27” “SET” to enter cooling
temp. setting,press to alter cooling temp.Press “SET”again to confirm.
Press "M"again "1" "27"
Press "M"again "2" "40"
Under running status, press to adjust the temperature.
.Press
Press “SET” to enter heating temp. setting,press to alter heating temp.
Press “SET”again to confirm.
Press “SET” to enter defrosting time setting,press to alter defrosting time.
Press “SET”again to confirm.
Swimming pool Heat Pump
5.1 Setting step
3
10
Press "M"again "3" "-7" Press “SET” to enter defrosting temp. setting,press to alter defrosting temp.
Press “SET”again to confirm.
Press "M"again "4" "13 " Press “SET” to enter exit defrosting temp. setting,press to alter exit defrosting temp.
Press “SET”again to confirm.
Press "M"again "5" "8 " Press “SET” to enter exit defrosting time setting,press to alter exit defrosting
time.Press “SET”again to confirm.
Press "M"again "6" "1 " Press “SET” to enter system quantity setting,press to alter system quantity.
Press “SET”again to confirm.
Press "M"again "7" "1 " Press “SET” to enter Automatic setting,press to alter.Press “SET”again to confirm.
Press "M"again "8" "1 " Press “SET” to enter Mode setting,press to alter.Press “SET”again to confirm.
Press "M"again "9" "0 " Press “SET” to enter water pump setting,press to alter.Press “SET”again to confirm.
Press "M"again "A" "40 " Press “SET” to enter return water temp. setting,press to alter .Press “SET”again
to confirm.
Press "M"again "b" "5 " Press “SET” to enter Overheat protection(heating mode) setting,press to alter.
Press “SET”again to confirm.
Press "M"again "C" "35 " Press “SET” to enter Electronic expansion valve setting,press to alter.
Press “SET”again to confirm.
Press "M"again "D" "5 " Press “SET” to enter Overheat protection(cooling mode) setting,press to alter.
Press “SET”again to confirm.
Press "M"again "E" "40 " Press “SET” to enter Max. temp. setting,press to alter.Press “SET”again to confirm.
Press "M"again "F" "2 " Press “SET” to enter Split temp. setting,press to alter.Press “SET”again to confirm.
Press "M"again "G" "-10 " Press “SET” to enter Ambient temp. protection setting,press to alter.
Press “SET”again to confirm.
Further explanation of PCB connections (refer P14 on user manual).
4.Clock setting
Under running or standby status,Press “SET” for 5 seconds,get a sound “B”,press to alter hour,press “SET”again
to alter minute.Press “SET”again to confirm.
5.Timer setting
Under running or standby status,Press “ ” for 5 seconds,get a sound “B”,press to alter hour of timer ON,Press
“ ”again to alter minute of timer ON.Press “ ” again to alter timer OFF.
To Next Page
Loading...