Fimar 7/SN - End-Day Cleaning; Removal of the Removable Parts Mod.Cn; Long Periods of Inactivity

OPER
A
TION AND
CLEANING
3
Mod.25/SN-25/CN-25/FN: Mix capacity 25 Kg.
Pour 8 litres of water into the pan and add 8 Kg. of flour
After 1-2 minutes of kneading, add another 9 Kg. of flour.
Mod.38/SN-38/CN-38/FN: Mix capacity 38 Kg.
Pour 13 litres of water into the pan and add 12 Kg. of flour
After 1-2 minutes of kneading, add another 13 Kg. of flour.
Mod.50/SN-50/CN-50/FN: Mix capacity 50 Kg.
Pour 17 litres of water into the pan and add 16 Kg. of flour
After 1-2 minutes of kneading, add another 17 Kg. of flour.
End-day cleaning
• At the end of a work day, unplug the machine from the power mains.
• Thoroughly clean the machine using neutral detergents.
• Wipe the machine outer parts with a damp sponge.
• Do not use steel wool or abrasive cleaning products.
Removal of the removable parts mod.”CN”
• Lift the head by rotating anti-clockwise the hand lever (mod.CN).
• For removing the pan rotate the lower flange clockwise and lift the pan
upwards (mod.CN).
INFORMATION: Before every operating cycle always check that the removable parts
are well locked to the machine. Lock the pan by rotating anti-clockwise the lower flange.
Long periods of inactivity
If the machine is to be left idle for long periods of time, turn off the main wall switch, thoroughly clean the
machine and cover it with a sheet to protect it from dust.
10