h)
Indoor temperature HI alert value setting;
i)
Indoor temperature LO alert ON/OFF;
j)
Indoor temperature LO alert value setting;
k)
Indoor humidity HI alert ON/OFF;
l)
Indoor humidity HI alert value setting;
m)
Indoor humidity LO alert ON/OFF;
n)
Indoor humidity LO alert value setting;
Note: In the alarm setting mode, press” RAIN1/+”
or ”RAIN2/-” buttons to change or scrolls the value.
Hold the button for 2 seconds can change fast.
When the alarm value is reached, the
corresponding alarm icon will flash and the
buzzer will ring for 2min. The ringing can be
stopped by pressing any button.
The setting mode will return to normal display while
idle 15s or by pressing the button “HISTORY”.
3.6 Factory Reset/Clear Memory
a.
Press the button “SET” and “HI/LO” at the same
time and power up the display will enter Factory
Reset All previously set value will be reset to its
default.
b.
Press the button “RAIN1/+” and “RAIN2/+” for 5s,
will register the transmitter signal for 3 minutes.
To Next Page
Loading...
Need help?
General