FingerTec TA100C Series - Access Level;Privilege; Defining Work Codes

15
REASONS WORK CODE
Check In 00
Check Out 01
OT start 04
Done 05
Sick Leave 10
Half-day Leave 12
Emergency Leave 11
Meeting Client 20
Outstation 21
Workcode Mode 1: Verification followed by work code
Workcode Mode 2: Work code followed by verification
CONTENTS
Access Level/Privilege
FingerTec terminals offer two types of access level or privilege.
PRIVILEGE USER ROLES
Normal User
Only use the terminal to verify your identity. You cannot access into
Menu and make changes into settings and system
Administrator You are allowed to access into menu to enroll users and edit settings
and system
Dening Work Codes
The terminal provides a work code feature
which allows users to key in predefined
numbers after verification. The work code
numbers are predefined in the TCMS V2.
The following table shows examples of
work codes.
Press Menu > User Mgmt > WorkCode >
Press ok to activate the menu > Select to
Create New workcode, Edit Workcode or
to Delete Workcode > Choose your pref
-
erence > Ok to save.
To add work code through the terminal,
Press Menu > User Mgmt > Workcode >
Menu > New > Enter Code Number eg: 02
> Enter Code Name eg: Emergency Leave
> OK to save.
RFID Card Function
The fingerprint terminals are versatile and some can accept card verifications. This chap-
ter covers the Radio Frequency Identification or better known as RFID system. The termi
-
nals accept RFID card with specifications of 64-bit, 125kHz.
ENROLLMENT OF RFID CARD
RFID can be enrolled alone, with fingerprint or with password. Each RFID card comes with
a unique ID and the terminals will read from the numbers and match it with the card.
Enrollment of RFID is easy. Press Menu > User Mgmt > New User > Enroll Card > ware card
at the induction area > OK.
CHANGING CARD ID
Press Menu > User Mgmt > Manage User > OK > Change Card > OK > Show a different
card > OK
.