Finn-Power FP110 IS/AS - User Manual

OPERATING
INSTRUCTIONS
FINN-POWER
FP20 IS/AS ¨
FP20 VS ¨
FP110 IS/AS ¨
FP110 VS ¨
FP120 IS/AS ¨
FP120 VS ¨
FP120S IS/AS ¨
FP120S VS ¨
FP140 IS/AS ¨
FP140 VS ¨
FP140X IS/AS ¨
FP140X VS ¨
MANUFACTURING YEAR
RELEASED 06/00
KEEP THIS MANUAL FOR FUTURE NEEDS
THE MACHINE HAS BEEN DESIGNED FOR CRIMPING HOSE FITTINGS.
LILLBACKA POWERCO SHALL NOT BE HELD LIABLE FOR ANY PRODUCT
WHICH HAS BEEN CRIMPED ON THE MACHINE. THE MACHINE HAS BEEN
DESIGNED TO OPERATE IN ROOM TEMPERATURE, IN DRY INDOOR
CONDITIONS AND IN SUFFICIENT ILLUMINATION. USING THE MACHINE
FOR ANY OTHER PURPOSE IS NOT ALLOWED WITHOUT WRITTEN
CONSENT FROM THE FACTORY.
Lillbacka Powerco Oy
P.O.B. 1
FIN-62301 Härmä, Finland
tel. + 358 6 485 4444
fax
+ 358 6 485 4400

Summary

WARNINGS

General Safety Warnings

Important safety precautions for operating the machine.

Danger Zones Identification

Highlights hazardous areas on the machine to avoid injury.

Control Panel IS;AS

IS;AS Control Panel Overview

Identifies EMERGENCY STOP, START, STOP, CONTROL OPERATIONAL, and MODE SELECTOR buttons.

IS;AS Operation Modes

Explains MANUAL, SEMI-AUTOMATIC, AUTOMATIC, and FOOT PEDAL operational modes.

Control Panel VS

VS Control Panel Overview

Details buttons and selector functions for the VS control panel.

VS Control Functions

Covers modes, diameter settings, die set selection, and data storage.

VS Control Settings and Modes

Details data storage, setups, mode selection, and tool change advice.

Installing the Die Set

Quick Change FP20

Quick Change IS;AS

Quick Change VS

Quick Change FP110 and FP120

Quick Change FP120 S

Quick Change FP140 and FP140 X

Setting the Crimping Diameter

Setting Crimping Diameter FP20 IS;AS

Guide for setting the crimping diameter on FP20 IS/AS models.

Setting Crimping Diameter FP110, FP120, FP120 S, FP140, FP140 X IS;AS

Setting crimping diameter for specific models on IS/AS controls.

Setting Crimping Diameter VS

Setting the crimping diameter using VS controls.

Crimping Operations

Manual Mode Crimping

Detailed steps for performing crimping in manual mode.

Semi-Automatic Mode Crimping

Detailed steps for performing crimping in semi-automatic mode.

Automatic Mode Crimping

Detailed steps for performing crimping in automatic mode.

Operation Modes

Automatic Mode; Foot Pedal

Using a foot pedal for automatic mode operation.

Adjustment Procedures

Retraction Diameter Adjustment IS;AS

How to adjust the retraction diameter on IS/AS machines.

Troubleshooting

Machine Not Working

Troubleshooting Guide

Machine Start Issues

Common causes and solutions for the machine not starting.

Motor Movement Issues

Crimping Force and Noise Issues

Crimping Diameter Variation

Finn-Power FP110 IS/AS Specifications

General

Turret Rotation Speed	30 RPM
Control	CNC
Sheet Size (max)	1270 x 1270 mm
Maximum Sheet Size	1270 x 1270 mm
Sheet Thickness (max)	6.35 mm
Maximum Sheet Thickness	6.35 mm
Hit Rate	400 hits/min
Punching Speed	400 hits/min
X-Axis Travel	1270 mm
Y-Axis Travel	1270 mm