Need help?Do you have a question about the Finn-Power KC800 and is the answer not in the manual?
Basic introduction to Finn-Power and their history since 1973.
Information on how the packed machine is transported and lifted.
Guidelines for protecting the machine against corrosion during storage.
Instructions for lifting and securing the machine on an even floor.
Guidance on recycling and disposing of packing materials responsibly.
Advice on recycling old machines and handling waste oil and filters.
Use of original parts, reading instructions, trained operators, and testing emergency stops.
Identification of hazardous areas on the machine with warning labels.
Steps to connect hydraulic hoses and electric cables to the hydraulic unit.
Instructions on filling the hydraulic oil tank and recommended oil type.
Cautionary notes and procedures for connecting the machine to the electrical supply.
Steps to perform a test run, including checking motor rotation and emergency stops.
Importance of greasing master dies and sliding plates for machine longevity.
Identification and description of the main operating components of the machine.
Explanation of the functions of the remote control stick for operating the dies.
Steps to start the machine from the supply disconnecting device.
How to navigate menus and functions using arrow and SET buttons.
Procedure for selecting and adjusting the crimping diameter.
How to perform fine adjustments to the crimping diameter using correction.
How to save and open crimping parameters from the memory.
Step-by-step guide for cleaning and installing adapter dies into master dies.
Details about FP170 special die sets and their attachment to adapter dies.
Instructions on setting the crimping diameter and considerations for pressure and deflection.
Step-by-step instructions for performing a crimp operation.
Explanation of the automatic slow-down feature at the end of the crimp cycle.
Troubleshooting steps for common issues like motor not starting or dies not moving.
Daily lubrication of master dies and sliding plates and general cleaning.
Procedure for changing the hydraulic oil and recommended oil type.
Steps for changing the filter insert, including purchase number.
Explanation of different password levels for accessing machine functions.
General| Brand | Finn-Power |
|---|---|
| Model | KC800 |
| Category | Industrial Equipment |
| Language | English |
To Next Page
