EasyManua.ls Logo

Finn B-70 - Pre-Start Checks and Procedures; Operator Safety Checks and Equipment Inspection; Engine Starting Procedure

Finn B-70
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
PRE-START CHECK:
SAFETY CHECK TO INSURE OPERATOR SAFETY:
1. A. Skid Unit - Check condition of all mounting hardware securing the Mulch Spreader to the
truck bed.
B. Trailer Unit - Inspect hitch, safety chains, lights, brakes and breakaway switch.
2. Check the signal horn for proper operation.
3. Inspect that all railings are in place and secure.
4. Insure that all guards are in place.
EQUIPMENT CHECK:
CAUTION: Equipment check is made with the engine off and all rotating
parts stopped.
1. Tool kit - see that it contains all prescribed items (see tool kit list page 30).
2. Check shredder box for foreign objects that could damage the equipment or injure workers.
3. Check fuel tank. Use 2-D diesel fuel oil. If operating at ambient temperature below 40ºF (4ºC) or
at an altitude exceeding 5000 feet (1524m) use No. 1-D fuel oil.
4. Check engine oil - refer to engine operators manual.
5. Check liquid level in radiator and overflow tank.
6. Inspect air cleaner for dust and dirt - refer to engine operators manual.
7. Engage and disengage clutch to determine if it “snaps” in and out of engagement.
8. Check beater chains and their mounting pins for damage or wear. Replace if necessary.
9. Lubricate equipment - use hand gun only (see lube chart page 9).
10. When not using an adhesive, remove the belt that drives the asphalt pump (running the pump dry
will permanently damage it).
STARTING PROCEDURE:
CAUTION: See safety section of the manual (pages 1-4) before operating
the machine.
1. Disengage the clutch.
2. Set throttle about ¼ open.
3. Turn key counter clockwise and hold until the glow plug indicator light goes out.
4. While holding in the safety switch button, turn the key clockwise until the starter engages, and
the engine starts.
5. Continue to hold safety switch in for approximately 10 seconds. Allow the engine to warm up
for 3 to 5 minutes.
NOTE: This engine has a safety system that will shut the engine off if the
engine oil pressure drops below 7 psi. or if the water temperature
reaches 230° Fahrenheit (11Centigrade).

Other manuals for Finn B-70

Related product manuals