12
MONTHLY:
1. Lubricate the Skid Steer per the lubrication chart on page 13.
2. Check the hydraulic oil level and top off as necessary.
3. Clean the engine air filter. See engine manual.
4. Visually inspect pivot pins for wear. Replace if necessary.
6. Check hydraulic lines and hoses for leaks, loose fittings, wear and deterioration. Immediately tight-
en any leaks or make any necessary repairs before operating.
7. Perform a good general inspection of machine and attachments. Repair or replace any worn or dam-
aged parts. Keep equipment in good operating condition.
ANNUALLY:
1. Change the hydraulic oil and filter.
2. Paint any bare or scratched metal surfaces.
3. Check and tighten all fasteners.
To Next Page
Loading...
