7
Chimney Recommendations
The termination cap should
be designed to inhibit down-
drafting without restricting
the exhaust discharge.
Chimney experts have determined that the
chimney termination should be at least 2' above
the highest portion of the roof that is within a
10' radius of the chimney.
The diameter of the chimney stack
should be consistent throughout its
entire length.
The chimney stack should have a built in air
tight clean out. WARNING: Do not operate
with clean out uncapped.
The chimney size should be at least
as large as the exhaust stack on the
furnace, but not more than twice it’s
size.
USE
CLASS "A"
HT2100 ALL
FUEL CHIMNEY
ONLY
When using a brick chimne, you must
line the entire chimney with stainless
liner. The liner must be the correct
size for the furnace - FC500 and
FC700: 6”; and for the FC1100: 8”.
To Next Page
Loading...
