8
Part Number 18002, G, 09/24/2019
Testing the Engine Shutdown System
The Engine Shutdown System can be tested by disconnecting either wire connection at the
Pressure Switch on the Fire Extinguisher. When the wire is disconnected, the engine shutdown
will activate. Verify that engines shut down and that all other equipment operates as expected.
The Helm Display unit will indicate that the Fire Extinguisher has discharged with a Red LED and
audible horn. Test the Helm Display by turning the ignition to the ON position. Press the
“Override” button, to activate the Override Mode. The Red LED will begin flashing, indicating that
you are now in Override Mode. You will now be able to restart your engines. Reconnect the wire
at the Pressure Switch and deactivate Override Mode.
Maintenance
The system should be tested periodically in the fashion described in the previous section.
Repairing Fireboy Engine Shutdown Control Component(s)
Fireboy Engine Shutdown Controls are not field serviceable. Components must be returned to the
factory for any repairs.
Returning Fireboy Engine Shutdown Control Component(s)
No product may be returned for credit or repair without a written “Returned Material
Authorization” (RMA) form. Purchaser must call or email Fireboy-Xintex 616-735-9380 or
fireboy@fireboy-xintex.com for a RMA. If due to extenuating circumstances a product is to be
returned, after approval it must be received in 100% new/resalable condition. Products stored by
the buyer for more than 26 weeks may not be returned for any reason. Maintaining fresh and
current inventory is the responsibility of the buyer.
To Next Page
Loading...
Need help?
General