FIRECORE F94T-XG - Troubleshooting

Troubleshooting
PROBLEM
CAUSE
SOLUTION
The laser line is
hard to see.
The laser tool is too far
from the target.
Move the tool closer to the
target.
The surrounding is too
bright.
Switch to receiver(pulse)
mode and find the laser
line with FD30 laser
receiver (sold separately).
Laser line is not
projected.
No battery installed or
battery is depleted.
Install battery or charge the
battery.
The power switch is
not pushed to the “ON”
position.
Slide the power switch to
the “ON” position.
Laser line flickers
for alert.
The surface where the
tool has been placed is
uneven or the tool is out
of its automatic self-
leveling range.
Place the tool on a more
level surface (within ±4°).