Operating Modes
Self-leveling Mode
Press or slide locking switch to turn the laser tool ON. Self-leveling is enabled
when the laser tool is switched to unlocked position. This laser tool projects
one horizontal beam and two vertical beams with automatic leveling range of
±4º. Once the leveling is finished, the laser beams won’t flash anymore. Short
press operation button to switch the laser line combinations in turn.
Manual Mode
When the pendulum lock is in its locked position, short press and hold the
"Manual" key for about 3 seconds until the laser beam appears, the laser line
flashes every 5 seconds. In manual mode, the laser tool won’t be self-leveling.
It could be held by hand or placed on an inclined surface to project a bright
laser beam in any direction.
Anti-shake Mode
Slide locking switch to turn the laser tool ON, press and hold the "Anti-shake"
key for about 3 seconds, the indicator flashes 3-5 times until stop flashing and
then enter the anti-shock mode. At this time, if the laser tool is tilted, then no
matter press any button, the laser line will not light up, this mode can be turned
off by slide locking switch to OFF position, or press and hold the "Anti-shake"
button for more than 3 seconds.
Pulse Mode
How to use the Firecore laser receiver with F94T-XG laser level?
First, turn on laser level's pulse mode——Press the "Receiver" button, the
straight laser line stops flashing and then enters the pulse mode.
Secondly, turn on the receiver and detect the laser lines. When the receiver
detects the laser lines, it will make "Beep" sounds.
To Next Page
Loading...