INSTRUCTION MANUAL FOR INSTALLATION, MAINTENANCE AND
USE Rev−12
PMKIE−DIMU−GB−12
14
GB
INDIRECT TILTING PANS, ELECTRIC TYPE
ˆPMKIE100˜ ˆPMKIE150˜ ˆPMKIE200˜ ˆPMKIE300˜ ˆPMKIE500˜
BY OPERATOR
DAILY
CHECKS
1. Check that the indicator of minimum water level gap is off. If on, see " Jacket Filling ".
2. Perform a thorough daily cleaning of the machine
QUARTERLY
CHECKS
1. Verifiy integrity :
− Mask commands:
− Emergency button:
− Pressure gauger
If it is damages , contact the service centre.
BY SERVICE TECHNICIAN
For each operation:
−
Carefully close all the panels. .
− The inside of the support housing should be kept clean.
− Electrical wiring should be kept securely connected and in good condition.
ANNUAL
CHECKS
/
ACTION
1. Check coupling panels, must be perfectly closed with all the screws.
2. Check the pressure gauge functional. Test to be performed without the product in the vessel,
displayed maximum pressure 0.65 bar (mod.100-150) 0.45 bar (mod.200-300-500).
3. Check the pressure switch functional. Test to be performed without the product in the vessel,
maximum pressure OFF 0.65 bar (mod.100-150) 0.45 bar (mod.200-300-500).
4. Check the sealing water system(load tap water).
5. Check that terminals connections of electrical parts are well fastened. Clean electrical parts .
6. Check the gas spring lid. If download replace it with an equivalent one.
7. Check wear sacrificial anode. Replace if necessary.
THREE-YEAR
CHECKS
/
ACTION
1.
Replacing contactors (with original parts).
2.
Replace the safety valve (with original parts).
3.
To Next Page
Loading...
General