English Customer Service: 1-844-FIRMAN1Page 12
7. Move choke lever located on engine to
“START” position.
8. PULL-TO-
PRIME:
Pull the starter cord
1-2 times. Pull slowly
until resistance if
felt and then pull
rapidly.
9.Move the choke lever to the “
RUN” position.
10. PULL-TO-RUN:
Pull the starter cord slowly until resistance if felt
and pull rapidly to run the unit.
NOTE: When the fuel selector switch is turned
to the “LPG” position, the indicator light will
become RED up to 4 minutes(before goes off).
Starting the engine successfully during these 4
minutes will turn the indicator light GREEN.
6. Disconnect all electrical loads from the
generator. Never start or stop the generator
with electrical devices plugged in or turned on.
If the engine fails to start in 1-2 pulls with choke in
the “RUN” position, then move choke lever to
To Next Page
Loading...
