7. Flip the engine switch to the "RUN"(I) position.
3. Connect the regulator(A) to both LPG cylinder 8. Push the battery power restore switch for about
and generator. Connect the power
cord(B) to the 3 seconds and then release.
LPG regulator port. See "Connecting liquid Petroleum
Gas(LPG/Propane) Cylinder" section on page 13, 14,15.
~I·.~·-
Use your fingers, slide the outer barrel back on ~•
the LPG quick connect hose fitting. While the outer
barrel is in the back position, insert the LPG hose
(included) into the inlet and release the outer barrel.
The barrel will automatically return and lock the
hose in the inlet. 9. Pull the choke lever out to the
"CHOKE" position.
4. Fully open the LPG cylinder knob.
5. Tum the fuel selector swtch to
"LPG" position(l30 o'clock).
6. Disconnect all electrical loads from the generator.
Never start or stop the generator with electrical
devices plugged in or turned on.
10.
PU LL-TO-PRIME:
Pull the starter cord 1-2 times. Pull slowly until
resistance if felt and then pull rapidly.
-
1·2VECES
,"' l-2FO/S
11. Push the choke button to the "RUN" position.
12.
PULL-TO-RUN:
Pull the starter cord slowly until resistance if felt
and pull rapidly to run the unit.
If the engine fails to start in 1-2 pulls with choke in the
"RUN" position, then move choke lever to "START"
position and repeat the "PULL-TO-PRIME" step.
English
Page 20 Customer Service 1-844-FIRMAN1
To Next Page
Loading...
