65
SETTING THE USER CODE
1
With the door open, press the reset button once, start setting code when the
yellow lights goes on.
2
Input new code (3-8 digits), and press “
*
“ or “#” button to confirm with 2
buzzer beeps, which indicates the acceptance and storage of the new code.
3
If the yellow light flashes with 3 buzzer beeps, the code changing is not
effective, and you need to try again.
SETTING MASTER CODE
1
Open the safe, input “0” twice and press reset button, start setting code
when the yellow light goes on.
2
Input the new master code (3-8 digits), then press “
*
“ or “#” button to
confirm, it will be confirmed by 2 beeps and the yellow light flashes two
times, then setting is done successfully.
3
If the yellow light flashes three times, it means the new code is
invalid and should be reset again.
OPENING THE SAFE WITH THE EMERGENCY KEY
Upon first receipt of the safe, or either the electronic circuit malfunction or codes
unknown, you can use the emergency key to open the safe.
1
Remove the cover of the emergency lock.
2
Insert the emergency key, turn it counter clockwise, then
turn the knob clockwise to open the door.
MOUNTING METHOD
Fix the safe in the place which is not easy to move.
1
Drill holes for expansion bolts (or clamping screws) in the right place.
2
Turn the expansion bolts counter clockwise to separate.
3
Use the expansion bolts (or clamping screws) to secure the case to the wall.
4
Make sure the case is mounted in place as required and then tighten all
screws.
CAUTION
Use the expansion bolt when there is a concrete wall surface. Use the clamping
screw when there is a wooden wall surface.
Opening Your Safe for the First Time
OPENING YOUR SAFE FOR THE FIRST TIME
Upon first opening, users should open the safe with the emergency key.
See “Opening the Safe with the Emergency Key” for details.
1
Remove emergency lock cover, then insert the emergency key, and turn it
counter clockwise.
2
Turn the knob clockwise to open the door.
CAUTION
Finish operation, pull out the emergency key and keep it in a safe place.
INSERTING THE BATTERIES
1
Open the door.
2
Insert 4 X AA batteries into the battery compartment.
3
Under normal condition, if both red and the green lights are on at the same
time, it means the voltage is low and you should insert new batteries.
CAUTION
Replace 4 fresh batteries by lining them up in a manner as indicated by the “+ “ and “ -
” signs. When out for longer than thirty minutes, you should reset the user’s code.
OPENING DOOR
1
Input your user’s code (3 to 8 digits), each press results in
one buzzer beep and yellow light flashes.
2
Press “
*
“ or “#” button, the green light will be on.
3
Rotate the knob clockwise and pull outwards within
5 seconds, the door is opened.
NOTE: An interior LED turns on for 30 seconds after the door is opened.
CAUTION
The user preset code “159”. Please input the user code again if the
yellow light flashes with three buzzer beeps.
CLOSING DOOR
1
Turn the knob counter clockwise to close the door.
AUTOMATIC LOCK
1
3 continuously wrong entries will activate the warning beep for 20 seconds.
2
6 continuously wrong entries will activate the warming beep for 5 minutes.
CAUTION
The key pad would be disabled during the beeping. You can only stop the beeps
by opening the safe with emergency key and power off by removing the battery.
Setting The User Code
To Next Page
Loading...
Need help?
General
