HINTS FOR BEST RECEPTION:
- The AM antenna is located inside the cabinet of the unit. If AM reception is weak, change
the position of unit until the internal antenna picks up the strongest signal.
- To insure maximum FM tuner reception, the Telescopic Antenna should be fully extended
and rotated to obtain the best possible station reception.
P
RESET RADIO STATIONS
This unit has 10 preset memories for the AM radio and 10 preset for FM.
1. Tap the POWER button to turn the unit ON.
2. Tap the MODE button repeatedly to select AM or FM mode.
3. Tune to the desired radio station either by “manually” or “automatically” tuning method.
4. Press and hold the memory MEM button to enable the program function. The preset
number “ CHANNEL 01” will show on the LCD display and flash.
5. Tap the or button to select the preset number you want to assign the station to.
6. Press and hold the MEM button to save the station, channel number stops flashing.
7. Repeat above steps 3-6 to store other stations.
Note: If you select an existing preset memory, the new radio station frequency will
replace the existing one.
RECALLING PRESET MEMORY CHANNELS
In AM/FM radio mode, recall the pre-set channels by tapping the MEM+ button repeatedly.
WEATHER BAND
CHANNEL
1) Weather Radio
1. Tap the POWER button to turn on the unit.
2. Tap the MODE button to select the "WB" icon, and it will show on the display.
3. Tap the TUNE+ / – button to select the weather band channel for your area.
4. Press the VOLUME+/ - button to obtain the desired sound level.
5. To turn the radio off, press and hold the POWER button.
Weather Band Channel Frequency Table
FREQUENCY(MHz)
CH1 162.400
CH2 162.425
CH3 162.450
CH4 162.475
CH5 162.500
CH6 162.525
CH7 162.550
Note: With regard to the NOAA Weather Band: You need to identify which channel receives
your local weather report. When you change locations either to another city or state,
you may need to choose a different band to get the local report in that location.
9
To Next Page
Loading...