OAD DEFAULT
If you forget some of your settings or want to clear all your previous settings, you may need
to go through a “LOAD DEFAULT” procedure to reset the SFA1150 back to its factory
settings.
1. Press the MENU button, and “TIME” is shown on the display.
2. Tap the or button until “LOAD DEFAULT” is displayed.
3. Tap the SELECT button to enter the setting mode, a blinking “NO” will show on the
display.
4. Tap the or button to select “YES” and then tap the SELECT button to confirm.
Wait for few seconds, and the unit will erase all your settings and restore the unit to its
factory defaults. “COUNTY” is displayed for initial setup. You can do some basic set-up
by following the instructions below or tap the SELECT button repeatedly to exit and do
a set-up from the main unit.
Note: Tapping the MENU button during “LOAD DEFAULT” set-up will not exit to the
main Menu. You must finish the whole set-up procedure or tap the SELECT button
repeatedly to exit to standby mode.
5. Tap the SELECT button and follow instruction in “Customizing the S.A.M.E County
Code settings” section”
to set the county in your area.
6. Tap the SELECT button after county is set, “TIME” menu is displayed for setup.
7. Tap the SELECT button again to set time, hour digits are flashing, follow the
instructions in CLOCK SETTING section to set the clock.
8. Tap SELECT button to finish clock setting, weather band “CHANNEL” is displayed for
setup.
9. Tap the SELECT button again, weather band CH 04 will display. Tap the or
button to select weather band in your area if necessary.
10. Tap the SELECT button to finish the setup, unit will return to standby mode with clock
display.
AUXILIARY INPUT
AUXILIARY INPUT
This unit provides an auxiliary audio signal input jack for connecting external audio devices
like MP3 players and CD players and to listen to them through the speakers of this unit.
1. Use an audio cable (not included) with one 3.5 mm stereo plug on each end.
2. Plug one end into the AUX-IN Jack on the main unit and the other end of the cable into
the Line-out Jack or Headphone Jack of your external audio device.
3. Turn on the unit and external audio device.
4. To select the auxiliary audio input, tap the POWER/MODE button repeatedly to select
AUX mode. ȾAUXȿappears on the LCD display.
5. The volume level can now be controlled through the main unit. Operate all other
functions from the external audio device itself.
6. Press and hold the POWER/MODE button for about 2 seconds to turn the unit OFF.
17
REVIEWING AN ALERT MESSAGE
The SFA1150 S.A.M.E Weather Alert Radio can store up to 10 different alerts (with
overlapping effective times) in memory. If the radio receives a new alert while a previous
alert is still active, it automatically overrides and displays the new alert in scrolling text. The
indicator lights will also change to the new alert received.
To Next Page
Loading...