Wake to ALARM, FM, AM or WEATHER RADIO
1. The Alarm (or FM, AM, Weather radio) will automatically turn on when alarm time is
reached. The volume level of the Alarm (or FM, AM, Weather radio) increases gradually
until it reaches the factory preset level. The Alarm (or FM, AM, Weather radio) sounds
for 30 minutes and then turn off automatically if the SNOOZE or MENU buttons are not
pressed.
Note: The VOLUME or buttons will adjust the FM, AM and Weather radio volume
levels, but not the alarm level.
2. To stop the Alarm (or FM, AM, Weather radio) immediately, tap the MENU button to turn
it off, and will reset it for the next day.
Notes:
• You must tune to your desired radio station (AM, FM or Weather) first before starting to
set the alarm time and selecting wake up mode.
• The selected wake alarm will ring again at the same time each day unless it’s disabled.
S
NOOZE FUNCTION
- When the alarm sounds, it can be temporarily stopped by pressing the SNOOZE button.
The Alarm indicator will be flashing.
- The alarm will be silenced for 9 minutes and then come again.
- This manual snooze operation can be repeated again and again when the selected alarm
is sounding.
- To turn off the snooze function immediately, tap the POWER button once.
LISTENING TO THE RADIO
1. Tap the POWER/MODE button to turn on the unit.
2. Tap the POWER/MODE button repeatedly to select AM, FM or Weather band. The
radio indicator displays in the sequence below.
WB FM AM AUX
3. To manually tune to a desired station, repeatedly tap the TUNE+ /
- button.
4. To automatically search for stations with strong signals, press and hold the
TUNE
+ /- button until the frequency digits on the display begin to scan, then release
the button. The tuner will stop on the first strong signal it finds.
5. Press the VOLUME+ / - button to obtain the desired sound level.
6. Press and hold the POWER/MODE button on the unit to turn unit into standby
mode after listenning.
Notes:
- Manual tune to select weaker stations that might be skipped during automatic tuning.
- If the automatic tuning does not stop on the exact frequency of the station, for
example, it stops on 88.9 MHz instead of 88.8 MHz, use the manual tuning method
to "fine tune" to the exact frequency of the desired station.
- In AM/FM radio mode, tuning frequency will be displayed for about 8 seconds before
8
revert to display the clock time.
To Next Page
Loading...