First Data FD400 - Terminal Placement Guidelines; Loading the Paper Roll

Let’s get started…
Typical set-up time: 5–10 minutes
Where to put the FD400
Ti
Terminal
TheFD400
Ti
terminalisdesignedtobeusedasahandhelddevice.
Whenplacingitonadeskortabletop,pleaseavoidareaswith
directsunlight,objectsthatradiateheat,excessivedustandother
electricaldevicesthatcancauseexcessivevoltage.
Note:InordertomeettheFCCRFexposureguidelinesforbody-
wornoperation,thisterminalshouldbekeptatleast8inches
(or20cm)fromthebody.
Loading the paper
Poptheprintercover’slatchtoopenthecover;thenliftthe
cover.Loadarollofpaper(AppletonPOSGradePlus600-2.4
isrecommended)intotheprinter.Thethermalprint-sideof
thepaperwillfeedoutfacingtheoperator.Closethecover
andtearoffanyexcesspaper.
4