4
REPLACEMENT PARTS
To order replacement parts, please call 877.454.4450 or visit www.rstlight-usa.com.
BATTERY INSTALLATION
STEP 1. Remove battery cap. Insert two batteries “+” terminals rst
(as shown above).
STEP 2. Reinstall battery cap. Hand-tighten until snug.
STEP 3. Ensure batteries are properly installed by pressing any button on the control
panel. The red LED “lock” should illuminate indicating the light is in Lockout
Mode. If it does not, repeat Steps 1 and 2, ensuring both “+” terminals are
facing up.
To Next Page
Loading...
