Remote Start Error Diagnostic
If the remote start fails to start the vehicle, the parking lights will flash three times immediately.
Following those three flashes the parking lights will flash again corresponding to the error table.
Number of
Parking Light
Flashes
Remote Start Error
1 Motor running or must first program tach
2 Key in ignition on position
3 Door open (manual transmission only)
4 Trunk open
5 Foot brake on
6 Hood open
7 Reservation off (manual transmission only)
8 Tach or tachless sensing failure
9 FT-DAS sensor shutdown
10 System is in Valet Mode
We recommend that you do not attempt any repairs on your remote starter. Contact your dealer or
call us directly.
Remote Start Shutdown Error Codes
If the remote start sequence has been completed and the vehicle shuts down, the vehicle’s parking
lights will flash 4 times, pause then flash again with the error code. Tap button 4 on 2 Way remotes
to initiate the shutdown error codes. On 1 Way remotes hold the Trunk and Start buttons together
for 2.5 seconds.
Number of
Parking Light
Flashes
Remote Start Shutdown Error
1 Lost engine sensing signal
2 Lost emergency brake signal
3 Foot brake triggered
4 Hood pin triggered
To Next Page
Loading...
Need help?
General
