https://
install.myfirstech.com
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
21
STEP 2: Remove the key from the vehicle’s ignition. The engine should remain running even after the key
has been removed. If the vehicle does not remain running, check the emergency / parking brake
connection and your tach connection. (“set” procedure based on feature 2-15 options) (If
keysense input is detected the CM will remain in this state until keysense input has been
removed) (For PTS vehicles please exit vehicle after entering reservation mode WITHOUT
pushing the PTS button)
STEP 3: Exit the vehicle and close the door. (Additional procedures may be required based on feature
2-15 option settings) The vehicle’s doors should lock then the engine should shut off upon
closing the door. If the vehicle’s engine does not shut off, check the door trigger connection, or
wait for the factory dome-light to go out. The Firstech system is in reservation mode and the
vehicle is ready to safely remote start. (For PTS vehicles please exit vehicle after entering
reservation mode WITHOUT pushing the PTS button)
Additional Notes
Reservation mode will be cancelled if the control module recognizes the vehicle’s door, hood or trunk
opening – or if the alarm is triggered. Each time the end user wants to remote start their manual
transmission vehicle, they must set the control module in reservation mode. Reservation mode settings
can be programmed with features 2-14 and 2-15
Blade Cartridge dock and Connector (SOLD SEPERATELY)
CMX Blade dock gives you the ability to use the Blade-AL and Blade-TB interface modules from Firstech
and ADS. With these modules you can virtually eliminate all wire connections between your control module
and bypass module. You only need to connect the main ignition harness and needed from the Black
20 pin Blade connector that may be required according to the vehicle specific Blade installation guide. For
more information on how to program and wire the Blade, please visit https://myfirstech.idatalink.com
(must use internet explorer when flashing modules, or the latest Weblink desktop program) for the
specific wiring diagram for that vehicle.
Blade system includes:
1. Blade-AL or Blade-TB (NOTE: These modules are blank and must be flashed on your computer.)
2. Black 20 Pin locking wiring harness
IMPORTANT: Vehicle specific install diagrams are not included and must be downloaded from the
iDatalink site when flashing the Blade. The CMX can be updated and allow feature options to be
changed using the same flashing website https://myfirstech.idatalink.com
WARNING: Manufacturer or seller assumes no responsibility for any injuries and/or damages caused by
improper care of the product such as decomposition, conversion, and transform done by a user voluntarily.
WARNING: There should be no wiring routed around any pedals which can cause a driving hazard.
“I can do this all day”
To Next Page
Loading...