https://
install.myfirstech.com
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
66
Option Programming procedures
How to Program Options
There are two ways to set options on the CMX control modules. You can use the FT-OP500-KIT or most
Firstech remotes. The remotes include 4 or 5 buttons 1- and 2-Way remotes.
Option Programming Using the FT-OP500-KIT
The OP500 can be used to change anything in the Option Tables. It is required to change settings in Special
Option Groups 1 and 2.
STEP 1: Make sure system is unlocked/disarmed. Connect the antenna cable (at the antenna end) to the 4 or
6 pin ports on the top of the OP500. Once connected, the OP500 will power up if
CN1 or CN3 on the control module is connected properly.
STEP 2: Use the left or right arrow keys on the OP500 to select option. Use the up or down arrow
buttons to select the option setting. “1” is the default setting, “2”, “3”, and “4” are the
optional settings.
Special Option Group 1: Change the timed output of the Diesel Timer or Auxiliaries 1
through 7.
Special Option Group 2: Change the Programmable Output Connections on the grey 20 pin
harness.
STEP 3: Hold the “W” (Write) button for 3 seconds. This finalize option changes to the control
module. Wait until OP500 displays “Success” before disconnecting.
To reset the options, hold the “R” (Reset) button and “W” (Write) buttons for 3 seconds. Then
hold the “W” button for 3 seconds.
Option Programming with FT-OP100 (valet button) (Limited feature group access 1-4)
STEP 1: Make sure the Control Module is in a disarmed/unlocked state
STEP 2: Connect FT Valet OP-100 button to the CM’s 4 pin blue antenna port
STEP 3: Go to Ignition on (without starting) + Foot brake input applied
To Next Page
Loading...