Firstech CM-X - Page 65

To Next Page

To Previous Page

CMX is t

Solution

https://

install.myfirstech.com

CMX

Master

Guide

HCP setting value description (SV)

SV 0 – DEFAULT SETTING by wire

SV 1 - Parking light: provides a (+) positive parking light output on any HCP programmed with this

setting.

SV 2 - Starter: provides a (+) positive starter output on any HCP programmed with this setting.

SV 3 - Ignition: provides a (+) positive ignition output on any HCP programmed with this setting.

SV 4 - Accessory: provides a (+) positive accessory output on any HCP programmed with this setting.

SV 5 - GWR (status): provides a (+) positive while remote started on any HCP programmed with this

setting. Can be used to activate interface modules during the remote start process.

SV 6 - FAA (Factory Alarm Arm): provides an 800mS (+) positive output with the arm/lock command on

any HCP programmed with this setting.

SV 7 - FAD (Factory Alarm Disarm): provides an 800mS (+) positive output with the disarm/unlock

command on any HCP programmed with this setting.

SV 8 - Horn: provides a (+) positive output with output control based on feature 3-08 option setting

when using any HCP programmed with this setting.

SV 9 - Dome light supervision: provides a (+) positive output with the disarm/unlock command, on any

HCP programmed with this setting, for up to 45 seconds or until ignition is on.

SV10 - AUX 1: provides a (+) positive output on any HCP programmed with this setting when AUX 1 is

triggered by any Firstech remote or Drone. Timing outputs will be based on feature 4-01, 4-03, 4-05, and

AU1 settings.

SV11 - AUX 2: provides a (+) positive output on any HCP programmed with this setting when AUX 2 is

triggered by any Firstech remote or Drone. Timing outputs will be based on feature 4-02, 4-04, 4-05, and

AU2 settings.

SV20 - Siren 2: provides a latched (+) positive output on any HCP programmed with this setting, only

with the full alarm or panic modes. May be used to power any additional horn or sirens while

the CMX is in full alarm or panic mode.

SV24 - AUX3 w/ RFID unlock: provides a (+) positive output on any HCP programmed with this

setting, (based on timing set for AUX 3) will activate AUX 3 when RFID proximity unlock

has been triggered. Active unlock from a remote or Drone will NOT trigger this AUX 3 output.

SV25 - Lock: provides an 800mS (+) positive output on any HCP programmed with this setting, with

the lock/arm command.

SV26 - Unlock: provides an 800mS (+) positive output on any HCP programmed with this setting,

with the unlock/disarm command.

SV28 - Trunk release: provides a 1 second (+) positive output (output timing based on feature 1-15 on

any HCP programmed with this setting, with the trunk release command.