https://
install.myfirstech.com
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
6
Control Module stats
- 5mA idle current draw (CM only, no accessories)
- 7-10mA additional current draw when adding a Firstech antenna
- 5-7mA additional current draw when adding a Firstech DAS/DASII
- 5-7mA additional current draw when adding an Idatalink interface module (Blade, ALCA)
- POC 2, POC 3, provide 500mA output
- All other (-) negative outputs provide 250mA, and each one is diode isolated from the other. They can be
doubled up to increase output.
- LC outputs are 3A max current handling.
- Siren outputs provide 2A MAX (+) positive outputs (2 pin brown CN, 20 pin I/O CN pin 2)
- CMX offers 3 High Current programmable outputs (HPC)
- CMX offers 11 programmable output channels (POC)
- CMX support 33 programmable output functions
- CMX offers 7 programmable Input channels (PIC)
- CMX supports 22 programmable input functions
- CMX supports up to 4 remote banks. (program new remotes in order to remove old remote ID’s)
- CMX supports multiple interface modules data to data at one time. (Blade + ALCA, 2-ALCA, Blade + Fortin
module, ALCA + Fortin module)
- CMX supports remote start on manual transmission vehicles
- CMX control modules are updateable
- CMX is default to remote start only mode, security features must be enabled using feature 3-06 option 2 or 3
Remote Programming Routine
Your remote can be programmed at any time using either method.
CMX will support up to 4 remotes at a time. NOTE: Once all 4 remote banks are programmed each
new remote that is programmed will delete a previously programmed remote
IMPORTANT: All remotes must be coded to the control module prior to performing all operations.
NOTE: ALL CMX Control Modules have 4 remote banks available
STEP 1: Activate programming mode by manually turning the vehicle’s key between the Ignition on and off
(or the Acc & On positions) five times within 10 seconds. The vehicle’s parking lights will flash
once with the successful completion of this step.
STEP 2: Within a 10 second period after the 5th ignition cycle tap (a quick 0.5 second press and
release) the Lock button on the Firstech remote. The parking lights will flash once to confirm
the transmitter has been coded. Repeat step 2 for each additional remote, up to 4. Note: if you
only have 2 remotes, please program each remote twice.
**parking lights will flash twice signaling the end of programming mode.
To Next Page
Loading...