https://
install.myfirstech.com
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
26
Pin 15 Black - [POC 8] Status/Ground while running (GWR) 250mA latched negative (-) output: This is an
optional output that will provide a latched negative (-) output 250mS before the ignition turns on, stays
on throughout the remote start duration and will be the last to shut off. This wire is commonly used to
trigger bypass / transponder modules. Note: There are 33 additional POC setting options for this
POC.
Pin 16 Gray/Black - [PIC 5] Hood Pin negative (-) (default setting) input: This input is a safety shut down and
alarm trigger. It prevents the vehicle from remote starting while the hood is open and triggers the alarm
if the hood is opened while the alarm is armed. You can connect this wire to the hood pin supplied
with this kit, or to a wire in the vehicle that shows (-) only while the hood is open. There are
additional options for this PIC, please see Special Options Group 3.
Pin 17 Green/White - (fixed output) Parking light 250mA negative (-) output. This will provide output
whenever the parking lights are activated for lock, unlock, remote start, diagnostics, and
programming the proper wire in the vehicle will test (-) when the parking light switch is in the on
position.
Pin 18 Yellow/Black - Engine sensing input (A/C): This wire is connected to the vehicle’s Tach or Alternator
wire and is required when using the tach and alternator sense setting. (You can also connect this wire to
the battery (+) post when using voltage sense to make it more accurate) IMPORTANT: To change
engine-sensing modes, you must change Option 2-10; Default option is set for tach input.
Pin 19 Red/Black - (fixed output) 2nd Starter output 250mA negative (-) output. This output provides a (-)
negative start output during the crank period of the remote start process.
Pin 20 White/Black - (fixed output) 2nd Accessory 250mA negative (-) output. This output provides a (-)
negative accessory output that will drop out during the crank period of the remote start process.
Connector Description
Connector 5 (CN5) Brown 4 Pin (UART data port) data to data only
This connector is available for use with Firstech accessories that support data to data communication. This data
port will support with the ANT-1WAF RFID antenna.
Pin 1 (B+) - Constant 12V positive (+) output
Pin 2 (B-) - Ground (-) output
Pin 3 (RX) - Input, this wire receives data
Pin 4 (TX) - Output, this wire transmits data
To Next Page
Loading...