https://
install.myfirstech.com
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
25
Pin 7 Blue - [POC 4] Unlock 250mA, 800mS (-) negative output: This is an optional output that will provide
only a negative (-) output pulse for unlocking doors. System will unlock doors and disarm alarm.
IMPORTANT: You must reverse polarity for (+) trigger door lock systems using the FT-DM700, FT-
DM600 or relays. For additional lock settings review Option Group 1. Note: There are 33 additional
POC setting options for this POC.
Pin 8 Violet/Black - [PIC 2] Trunk zone input (default setting) (-) programmable input: This is an optional
input that will monitor the vehicle’s trunk status. The proper wire will provide a (-) trigger while the
trunk is open. There are additional options for this PIC. Please see Special Options Group 3.
Pin 9 Orange/White - [POC 5] Factory Alarm Disarm (FAD) 250mA, 800mS negative (-) output: This output
will provide a (-) pulse during unlock and every time prior to the GWR (ground when running: aka.
Status output) turning on during the remote start sequence. It is typically used to disarm factory security
systems. Note: There are 33 additional POC setting options for this POC.
Pin 10 Red/White – [PIC 4] Door zone input: This wire monitors negative (-) or positive (+) trigger door-
pins. The proper wire in the vehicle, will provide a (-) trigger or a (+) trigger only when the doors are
opened. You will need to test the vehicle wire for proper polarity and set feature 4-09 to the correct
option. NOTE: When feature 4-09 is set to option 1 this wire can be used as a programmable input
channel (PIC). There are additional options for this PIC. Please see Special Options Group 3.
Pin 11 Orange - [POC 6] Factory Alarm Arm (FAA) 250mA, 800mS negative (-) output: This is an optional
output that will provide a (-) pulse during lock, after crank and again after the remote start shuts down.
The FAA output can be configured using feature 1-05. Note: There are 33 additional POC setting
options for this POC.
Pin 12 Brown/White - [PIC 3] Key Sense INPUT (-) programmable input: This input can monitor the
keysense provided by the vehicle for manual transmission reservation mode, use of RFID and/or
Passive arming. There are additional options for this PIC. Please see Special Options Group 3.
-In case of reservation mode for manual transmission the keysense input will not allow the CMX
to complete reservation mode until the (-) input to the CMX is removed.
-In case of passive arming the CMX will monitor the keysense input and not allow the CMX to
arm/lock passively until (-) input is removed.
Pin 13 Violet/White - [POC 7] Trunk release 250mA, 1 sec. negative (-) output: This is an optional output that
can be used to activate the trunk or rear hatch release. Use CN1/CN2, HCP if the vehicle is equipped
with a (+) trunk release. System will unlock doors and disarm alarm prior to trunk release (this
procedure is programmable with feature 1-07 and the output time can be changed using feature 1-15).
Note: There are 33 additional POC setting options for this POC.
Pin 14 Pink - Trigger Start (+) programmable input. This is an input (+) that can be used to activate the start
sequence when triggered 1, 2, or 3 times based on option selected on feature 2-04. This
can be done with a door lock motor output being operated by a factory keyless entry or another
external source. There are 3 additional options for this Input please check feature 4-10.
To Next Page
Loading...