https://
install.myfirstech.com
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
67
STEP 4: Push the valet button 5 times holding it on the 5
th
time for the following time lengths to reach
the desired feature group:
1) 2 seconds → Option Group #1 (w/ light flash 1 time and siren/horn 1 chirp)
2) 4 seconds → Option Group #2 (w/ light flash 2 times and siren/horn 2 chirps)
3) 6 seconds → Option Group #3 (w/ light flash 3 times and siren/horn 3 chirps)
4) 8 seconds → Option Group #4 (w/ light flash 4 times and siren/horn 4 chirps)
If you would like to reset all features to their default option setting push the valet button 10 times and
hold on the 10
th
time. Once complete, the parking lights will flash, and siren/horn will sound 5 times
to confirm reset.
STEP 5: Once the Option group has been selected release the programming button. Then push and
release the programming button again to select the feature number you wish to change. Once
selected, wait for the parking light flash, and siren/horn to sound confirming the feature
number you have selected.
STEP 6: Once you have confirmed the feature you’ve selected push and release the valet button to
select the desired option. Once selected wait for the parking lights to flash and the siren/horn
to sound confirming the option you have selected.
STEP 7: Once finished turn ignition off, please test function to verify successful feature option change
Option Programming Using a Remote
Using a remote is a timed process so review this section before beginning. Options cannot be programmed with
1 button remotes. IMPORTANT: Special Option Groups cannot be programmed with remotes – OP500 must
be used.
STEP
1: Select the option you wish to program. (Use the corresponding table shown on the following
page
)
STEP 2: Scroll through menu waiting for 1 parking light flash and/or siren chirp per line.
STEP 3: Once finished scrolling through menu, wait for the parking lights and/or siren chirp to confirm
the option number. i.e. option 2-04 will flash and/or chirp 4 times. Select your option using the Lock,
Unlock, Trunk, or Start buttons.
NOTE: Resetting to Factory Defaults: To reset the options in a menu, enter the menu using your
remote. To reset options with a 2 Way remote, tap the Trunk button 3 three times. To reset options
with a 1 Way remote, tap the Key/Start button 3 times. Wait for parking lights to flash and/or siren
chirp between each tap. After the third tap, the menu will reset back to default. This must be done for
each option menu that must be reset.
To Next Page
Loading...