https://
install.myfirstech.com
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
38
FO2 - After shut down only and first lock: This option triggers the FAA after every successful remote
start shut down, and with every first lock command. (First lock command is the first arm/lock command
sent after the CMX has been disarmed or unlocked.)
FO3 - After Start only: This option triggers FAA after every successful remote start.
FO4 - After shutdown only: This option triggers the FAA after every successful remote start shut
down.
1-06 N/A: This feature has been removed please see features 2-14 and 2-15 for reservation mode
options
1-07 Unlock / Disarm with Trunk Release:
FO1 - Unlock, Factory Alarm Disarm (FAD) trunk release: This option will send unlock and FAD
outputs prior to sending the Trunk release output. This applies to analog and data to data situations.
FO2 - Factory Alarm Disarm (FAD) with trunk release: This option will send the FAD output prior to
sending the trunk release output. This applies to analog and data to data situations.
FO3 - Trunk release only: This option will only send the trunk release output when triggered. This
applies to analog and data to data situations.
1-08 Passive Arming: When using any passive arming option, the user must also activate “Passive” feature
using a Firstech remote or Drone (please check specific remote user ’s manual for steps to activate
passive)
FO1 - OFF: (default)
FO2 - Passive locking with passive arming: This option when passive is activated, will send lock/arm
outputs to lock/arm the CMX 30 seconds after the last zone is closed. The CMX will flash the parking
lights and chirp the siren 1 time every 10 seconds 3 times total as a warning that it is going to Arm/lock
itself.
FO3 - No lock output with Passive arm: This option, when passive arm feature is activated, will NOT
send the lock command one the CMX has passively armed itself. The CMX will flash the parking lights
and chirp the siren 1 time every 10 seconds 3 times total as a warning that it is going to arm itself.
FO4 - “Passive Locking/Arming with RFID”: This option will allow the Passive locking with Passive
arming to LOCK/ARM the system 15 seconds after an RFID capable remote has left proximity of the
antenna. IF THE REMOTE IS WITHIN RANGE OF THE ANTENNA FOR 5 MINUTES OR
MORE, CMX WILL STOP THE PASSIVE ARMING SEQUENCE.
ANY ACTION FROM A FIRSTECH REMOTE, DRONE, KP SENSOR, IGNITION ON, OR
ZONE OPEN WILL AUTOMATICALLY RE-START THE PASSIVE ARMING SEQUENCE.
1-09 Ignition Controlled Locks (DRIVE LOCK): When FO 2-4 are selected, the user must also activate the
“drive lock” or ignition-controlled door locking feature using a Firstech remote or Drone. (Please check
specific remote user ’s manual for steps to activate Drive lock.)
FO1 - Off: (default)
FO2 - On: This option (when activated with the Firstech remote or Drone) will provide a door lock
output when the foot brake is applied, or 12 Volts is applied to the foot brake input on the CMX. The
CMX will also provide a door unlock output as soon as the key is turned off or the parking brake is set
(must have parking brake input connected or provide parking brake input from data module)
To Next Page
Loading...