https://
install.myfirstech.com
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
45
2-13 Timer Mode: (Note: Must be set to on to operate timer mode). This feature enables the user to activate and
deactivate Timer Mode (see option 2-06) using the Firstech remote or accessory (see the user manual for
that remote for instructions).
FO1 - Off: (default)
FO2 - On: user must still activate timer mode using their Firstech remote or accessory.
FO3 – START with Alert: This option when enabled will allow for the remote start to active and will
also send an extreme temp alert (based on features 2-05, 2-06, 2-08, 2-09 option setting) to a
programmed Firstech 2-way LCD remote or Drone in the form of “CAR CALL” (user must still activate
timer mode using their Firstech remote or accessory)
FO4 – Alert ONLY: This option when enabled will ONLY send an extreme temp alert (based on
features 2-05, 2-06, 2-08, 2-09 option setting) to a programmed Firstech 2-way LCD remote or Drone in
the form of “CAR CALL” (user must still activate timer mode using their Firstech remote or accessory)
2-14 **Reservation Mode “Enter with”: ATTENTION: YOU MUST select a reservation “enter with”
option in order to enable manual transmission capabilities.
This feature will allow the user to customize the process used to enter reservation mode (manual
transmission set up mode) Once user has entered reservation mode there is a 5-minute window to “set”
or complete reservation mode before the CM cancels reservation mode. Warning: DO NOT CUT
THE LOOP FOR MANUAL TRANSMISSION VEHICLE Manufacturer or seller assumes no
responsibility for any injuries and/or damages caused by this improper conversion and transform
of the product done by a user voluntarily.
FO1 – OFF (Automatic transmission) (default): This will disable reservation mode and should be
used for Automatic transmission vehicles.
FO2 – Parking/E-Brake set: When set to this option, when the CM sees the parking/E-Brake input
(analog or through data) it will activate the necessary ignition, accessory outputs and interface
module, to leave the vehicle running and enter manual transmission reservation mode.
FO3 – Parking/E-Brake set + Hold Start button for 2.5 seconds: When set to this option, the CM
will need Parking/E-Brake input (analog or through data) AND a start command from a remote (hold
start button for 2.5 seconds) to activate the necessary ignition, accessory outputs and interface
module, to leave the vehicle running and enter manual transmission reservation mode.
FO4 – 2x’s Parking/E-Brake: (requires action) Set => Release => Set (within 7 seconds): When
set to this option, the CM will need Parking/E-Brake input (analog or through data) set then release
then set again within 7 seconds to activate the necessary ignition, accessory outputs and interface
module, (if foot brake input is applied during this process the CM will enter reservation mode as
soon as it is released) to leave the vehicle running and enter manual transmission reservation mode.
NOTE: When using this option “IDLE MODE” is available. To activate Idle Mode, set E-
Brake 1 time, then hold the remote start button on the remote for 2.5 seconds. The system
should flash the parking lights 1 time to indicate Idle mode has been engaged. The driver may
now exit the vehicle leaving it running for as long as needed.
To Next Page
Loading...