Firstech CM-X - Page 70

CMX is t
he
Solution
https:// install.myfirstech.com
CMX
Master
Guide
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
70
Troubleshooting
Remote Start Error Codes
If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following
those two flashes the parking lights will flash again corresponding to the error table below:
Number of
Parking Light
Flashes
Remote Start Error
1
Motor running or must program tach before 1st remote
start
2 Key in ignition on position
3 Door open (manual transmission only)
5 Foot brake on
6 Hood open
7 Reservation has NOT been set (manual transmission only)
8 Vehicle failed to remote start after all 3 attempts
9 DASII safety shutdown
10 System is in Valet Mode
2 Way remotes will display the error number “Start Err##” on the LCD.
Remote Start Shutdown Error Codes
If the remote start sequence has been completed and the vehicle shuts down, the vehicle’s parking lights
will flash 4 times, pause then flash again with the error code. Tap button 4 on 2 Way remotes to initiate the
shutdown error codes. On 1 Way remotes hold the Trunk and Start buttons together for 2.5 seconds.
Number of
Parking Light
Flashes
Remote Start Shutdown Error
1 Lost engine sensing signal (Tach/Alternator/Tachless)
2 Lost emergency brake signal (Manual Transmission)
3 Foot brake triggered
4 Hood pin triggered
Remote Start Reservation Mode Diagnostic Codes
If the remote start sequence has been completed and the vehicle shuts down, the vehicle’s parking lights
will flash 4 times, pause then flash again with the error code. After reservation mode failure, tap button 4 on
2 Way remotes to initiate the shutdown error codes. On 1 Way remotes hold the Trunk and Start buttons
together for 2.5 seconds.