Firstech CM-X - Page 8

To Next Page

To Previous Page

CMX is t

Solution

https://

install.myfirstech.com

CMX

Master

Guide

4. Drone Mobile app will allow a user to enable/disable VALET mode within the vehicle settings section.

1. Open the Drone Mobile app

2. Open settings

3. Open “Vehicles”

4. Select Vehicle

5. Open “System”

6. Toggle Valet on or off

7. Tap “Save” top right corner of the app.

**NEW

5. The CMX supports a (-)NEG. Trigger Valet mode input that can be connected to a latching or momentary toggle

switch (NOT INCLUDED). ENTER and EXIT valet mode will use the same procedure. NOTE: When the

system has been set to NEG Trigger Valet mode input, procedure 1 WILL NO LONGER FUNCTION!

1. Hold the (-) Valet input to ground for minimum of 5 seconds

2. After 5 seconds to ground, tap the (-) Valet Input to ground 5 times

3. The park lights will flash

-1 time for enter Valet mode

-2 times for exit Valet mode

NOTE: When using this feature with security features please make sure the switch is mounted

discretely and the user knows where to find the switch in case of emergency.

The System can be taken out of Valet mode by one of the following procedures:

1. No Remote: If there are no remotes programmed or there are no remotes available you can exit Valet

Mode by turning the key to the ignition on or ‘Run’ position then press and release the foot brake pedal

10 times within 10 seconds. This procedure will only deactivate Valet Mode it will not activate Valet

Mode. The vehicles parking lights should flash 2 times to indicate the system has exited valet mode

2. With Remote: While within remote range of the vehicle, using a 4-button remote, press and release the lock

and trunk button together simultaneously for a half second. The vehicle’s parking lights will flash 2 times to

indicate the system has exited Valet Mode. When using 3 or 5-button remote there will be remote specific

steps to exit valet, please see remote user’s manual for further instructions.

3. Using Drone mobile app as stated above.

4. Using the (-)NEG. Trigger Valet Input as stated above.