Copyright 2014 Firstech, LLC. Page 11
CM7000 Master Guide
Alarm and Starter System
techfeed.compustar.com
STEP 2: Wait 30 seconds then test the impact sensitivity.
Firstech Shock Sensor
For best results mount the shock sensor using the included hardware to a central location in the vehicle
that can be accessible for adjustment. You can also use wire ties to attach it to a large wire harness or dash
brace but you may experience extreme sensitivity. There is a small dial on the sensor that ranges from Off
to 10, the higher the number on the dial the greater sensitivity to impact. A small adjustment to the dial can
make a significant difference in sensitivity for both 1st and 2nd stages. Recommended dial settings for most
vehicles is somewhere between 2 & 4.
FT-EZGO Setup
The FT-EZGO from Firstech will unlock/disarm the vehicle when in range. It is capable of proximity lock/arm
and unlock/disarm when in or out of range off the vehicle. There is a manual override button located on
the back of the EZ-GO remote. It will lock/arm, unlock/disarm by press and releasing the button for ½ of
a second (0.5 seconds). It will also trigger the trunk release output by press and releasing the button for ½
second (0.5 seconds) then holding for 2.5 seconds.
Installing The FT-EZGO
STEP 1: Set Option 1-14 to Setting 2, 3 or 4
STEP 2: Connect included Blue 6 Pin (With Ground Wire) to Black 6 Pin to control module. If connecting
to a 4 Pin to 4 Pin antenna, use the included 6 Pin to 4 Pin adapter.
STEP 3: Connect the ground wire from the included 6 Pin to 6 Pin cable to vehicle’s ground. Warning:
Failure to connect this wire WILL result in damage to your FT-EZGO antenna (ANT-
RFID).
STEP 4: If you are using an additional RF kit the antenna cable will connect to the blue 6 pin connector
on the EZ-GO antenna either directly or using the 6 to 4 pin adapter harness included with the
EZ-GO kit.
STEP 5: Find a spot to mount your ANT-RFID on the windshield. This is recommended for optimum
range. For more specific mounting location information visit us at techfeed.compustar.com
under the Authorized Tech section document titled: “FT-EZGO Recommended Mounting
Locations.”
STEP 6: Program your EZ100-R using the standard remote programming procedure along with any
additional RF Kit remotes to the control module (Maximum 4 Remotes including EZ100-R). You
are now ready to test your FT-EZGO system.
Testing The FT-EZGO
STEP 1: Turn the proximity lock/unlock feature on by holding the button on the EZ100-R for 8-10
seconds. You will get one parking light flash and/or siren chirp. To deactivate the proximity
feature simply hold the button again for 8-10 seconds and you will get two parking light flashes
and/or chirps to indicate your feature is off.
To Next Page
Loading...
Need help?
General
