To Next Page

To Previous Page

IMPORTANT: Any and all remotes must be coded to the control module prior to performing any and all

operations.

STEP 1: Activate programming mode by manually turning the vehicle’s key between the Ign On and Off

(or the Acc & On positions) five times within 10 seconds. The vehicle’s parking lights will flash

once with the successful completion of this step. Note: if the foot brake (+ brake input) is

applied during this process your system will enter Valet Mode and the remotes will

not program.

STEP 2: Within a 2 second period after the 5th ignition cycle tap Button I on two way remotes or the Lock

button on one-way remotes for a half second. The parking lights will flash once to confirm the

transmitter has been coded. Repeat for additional remotes, up to four. Note: if you only have

2 remotes please program each remote twice.

Exiting Programming: Programming is a timed sequence. After 2 seconds

the parking lights will flash twice signaling the end of programming mode.

Programming Multiple Remotes: After the confirmation flash given in STEP

2, code additional remotes by tapping Button I on two way remotes or

the Lock button on one way remotes. The parking lights will flash once

confirming each additional remote. This system can recognize up to four

remotes. Note: if you only have 2 remotes please program

each remote twice.

CM7000 Master Guide

Alarm and Starter System

techfeed.compustar.com

Remote Programming Routine

Valet Mode

Valet Mode disables all system features except for the keyless entry. Use Valet when servicing or loaning your

vehicle to others to avoid any inconvenience or mishap when operating the vehicle. There are no visual

indicators when the security system is in Valet Mode. There is a parking light indication when remote starting

in Valet Mode. (3 flashes followed by 10 flashes). Also when in Valet Mode, the keyless entry feature will still

operate.

The system can be put into valet mode one of 3 ways:

1. While holding the foot brake (12V+ brake input), cycle the key to the Ignition or ‘On’ position and then

back to the ‘Off’ position 5 times within 10 seconds. The parking lights will flash once indicating that the

system has entered Valet Mode.

2. Turn the key to the Ignition or ‘On’ position then using a 4 button remote press and release the lock and

trunk buttons together simultaneously for a half second. The vehicle parking lights will flash 1 time to

indicate the system has successfully entered valet mode.

Firstech CM7000 User Manual

Questions and Answers: