Copyright 2014 Firstech, LLC. Page 37
CM7000 Master Guide
Alarm and Starter System
techfeed.compustar.com
2-14 PIC 1 (-): Programmable Input Channel provides 4 options for negative input to the CM7.
FO1 - (-) negative E-brake (aka: parking brake) input: This option allows the CM7 to read
input as e-brake which is needed to enter reservation mode or turbo timer mode. (Note: required for
manual transmission or turbo timer mode).
FO2 - (-) negative parking light reminder input: This option allow the CM7 to read input as
parking light reminder. If this input has ground, as soon as the system is locked/armed it will send a
notification to a 2 way LCD or Drone indicating parking lights are still on.
FO3 - (-) negative trigger start input: This option will allow the CM7 to read input as a trigger
to start based off of feature 2-04 selection.
3-01 Parking Lights while Remote Started: This feature changes the parking light behavior during remote
start.
FO1 - Constant output: This option will keep the parking light output (+ and -) on steady
throughout the entire runtime (runtime based on feature 2-07 selection)
FO2 - Flashing output: This option will flash the parking light output (+ and -) throughout the
entire runtime (runtime based on feature 2-07 selection)
FO3 - Off: This option turns the parking lights off while the vehicle is remote started.
3-02 Confirmation chirps: This feature will allow the user to select a shorter siren output time to simulate a
quieter arm/disarm/start output.
FO1 - 30mS: This is a 30 milliseconds siren output with arm, disarm, and start confirmation chirps.
It will produce a “medium” volume sound. (Softer than the standard 60mS output)
FO2 - 15mS: This is a 15 millisecond siren output with arm, disarm, and start confirmation chirps. It
will produce a “short” or quiet volume of sound. (Significantly softer than the standard 60mS output)
FO3 - 60mS: This is a standard 60 millisecond siren output with arm, disarm, and start confirmation
chirps.
To Next Page
Loading...
Need help?
General
