What do I do with the thick blue wire on Connector 1?
A: It is used to power a (+) 2nd Ignition. You can also change the output via jumper within the control module. It can
be changed to power a (+) 2nd Accessory or (+) Parking light wire.
I need a ground when armed wire, does the control module have one?
A: You can use pin 1-blue/white wire on the Grey Connector 5. You must cut this wire and place a diode in
line so that when the ignition on the other side of the relay goes to ground and it doesn’t back feed to your
accessory. Install the stripe side of the diode facing the control module.
What do I do with the 6 Pin harness on Connector 3?
A: The 6 Pin harness on Connector 3 is used for low current ignition harnesses. DO NOT use this harness
with the Connector 1 Harness (the high current power harness) this is ONLY to be used in LOW current
applications where High current is not needed for any reason.
Does the CM7 series have tachless mode?
A: Yes. The CM7000 and CM7200 are tachless. For details, review the “Common Procedures” section of
this manual.
All my connections are made and remotes programmed, how do I program the tach?
A: Review the “Common Procedures” section of this manual. You must have your remotes programmed,
start your vehicle, then hold the remote start button. Vehicle should chirp and/or flash once if it programs,
three times if it does not like the tach source.
The vehicle will lock and unlock, but will not remote start or flash the parking lights.
A: The system is in Valet Mode. Tap the Lock and Trunk Buttons for a half second to exit Valet Mode. You
can also turn the ignition ‘On‘ and press the foot brake 10 times within 10 seconds.
Whenever I try to arm the vehicle, it chirps the siren 3 times and will not arm.
A: Check the hood and trunk trigger inputs.
Do the door locks flip flop in polarity?
A: No. You can use the FT-DM700 relay pack for high current positive (+) locks, or the FT-DM600 harness
used for low current 600mA positive (+) locks.
What are Firmware Version Diagnostics?
A: When you turn the Ignition on and hold buttons 1 and 4 or Lock and Start for 2.5 seconds then the
parking lights will flash 1 time on the CM7 series showing V.1.
Copyright 2014 Firstech, LLC. Page 54
CM7000 Master Guide
Alarm and Starter System
techfeed.compustar.com
To Next Page
Loading...
Need help?
General
