Transporting the Scooter (load/ unload position)
The Quingo Flyte is transported using the Quingo Docking Station. There is minimal lifting
required to be able to load/unload the scooter from your car.
The following process shows how to fold your Quingo. This can be in a confined storage
location or as you prepare to load it into your car:
• To ensure the scooter is folded to a compact position, make sure the seat is in the
rear position (farthest from the tiller).
• Remove both armrests.
• Remove front basket and center basket.
1. Fold the back support down flat.
2. Push the green seat release lever and tilt the front of the seat upwards and over
until the seat unlocks.
3. Now push the seat assembly forwards where it will lower the Flyte’s deck.
4. Release the tiller locking lever and lower the tiller onto the seat’s hook-and-loop
fastening.
5. Folding is complete
Note: -Always check that the tiller is in the correct folded position for your vehicle when
loading.
To Next Page
Loading...