fischertechnik ROBOTICS TXT Discovery Set

To Next Page

To Previous Page

TXT

Discovery Set

ROBOTICS

First Steps

Now that you have made all of the

preparations and read the information, you can

finally start working.

This chapter describes how to:

▯ build the first simple model, a ventilating fan, and connect it to the

ROBOTICS TXT Controller,

▯ connect the ROBOTICS TXT Controller to the power supply and PC,

▯ load the ROBO Pro Software and test the model,

▯ load and start a ROBO Pro program, and

▯ create and start your first simple program with ROBO Pro

Click here, to see the first, easy-to-understand steps.

Since you will be working particularly with the

ROBO Pro Software in addition to the fischertechnik

components themselves, you should be familiar with the

details for writing programs. And because this is explained

very clearly in Chapters 3 and 4 of the ROBOProHelp, it

is best at this point to continue by working through these

chapters carefully.

The following tip also applies here: Take your time and

concentrate; then you will have that much more fun with the models

later.

fischertechnik ROBOTICS TXT Discovery Set - First Steps