Fisher & Paykel ActiveSmart RS36A72J - Water Dispenser Usage; Water Dispenser Operation

14
8 ATTACH SIDE TRIM BRACKETS
1 Break off the datum lip to each side trim bracket
anddiscard.
Repeat for all side trim brackets x6.
Discard
3 Fix side trim brackets to the side of one enclosure
withscrews x2 (#8 x 16 pan head Phillips screw).
Ensure screws hold tight.
Repeat for remaining side trim brackets.
¾” (19mm)A
~
4” (100mm)
~
35” (900mm)
~
4” (100mm)
2 On one side of the finished enclosure, starting from the
top, measure ¾’’ (19 mm) from the front cabinetry edge
towards the back with the side trim bracket (refer to A).
Mark side trim bracket screw locations for the top,
center and bottom of the finished enclosure.
Repeat on the right side of the finished enclosure.
¾” (19mm)
IMPORTANT!
Before installing your appliance, ensure the dimensions
of the finished enclosure are correct for your appliance
following the ‘Product and cavity dimensions’ section.