Fisher & Paykel ActiveSmart RS36A72J - Assemble Door Panel Set

20
The assembly of Fisher & Paykel door panel sets (EZKleen stainless steel door panels) and custom door panel sets are outlined below.
For Fisher & Paykel door panel sets, only remove the protective film for handle installation. This will protect the finish of the door panels until installation is complete.
!4 ASSEMBLE DOOR PANEL SET
1 Mounting handle (Refer to A)
For Fisher & Paykel door panel sets, remove
theplastic plugs from the handle holes x4.
Align the handle to the holes and secure
withscrew handle x4 (M5 x 25 pan head
socketscrews).
For custom panels, ensure handle is secured
2⁄” (65 mm) from the inner edge of the panel
to the center – this will avoid interference with
bracket installation.
2 Hanging bracket (Refer to B)
For Fisher & Paykel door panel sets, align the
bracket to the holes and secure with screws x4
(M5 x 14 Mush Phillips SS).
For custom panels, secure bracket with screws x4
(#8 x 16 Mush washer screws).
3 Side brackets and straps (Refer to C)
For Fisher & Paykel door panel sets,
align bracket and strap to the holes
on the side of the panel and secure
with screws x2 (M5 x 14 Mush
Phillips SS).
For custom panels,
secure bracket with
screws x2 (#8 x 16
Mush washer screws).
Repeat this process
for all brackets and
straps, and remaining
French door panel.
B
French door panels Drawer door panel
4 Mounting handle (Refer to D)
For Fisher & Paykel door panel sets,
remove the plastic plugs from the handle
holes x4. Align the handle to the holes and
secure with screw handle x4 (M5 x25 pan
head socket screws).
For custom panels, ensure handle screw
heads are counter sunk into the back
of the panel to avoid interference with
hanging bracket.
5 Hanging bracket (Refer to E)
For Fisher & Paykel door panel sets, align
the bracket to the holes and secure with
screws x6 (M5 x 14 Mush Phillips SS).
For custom panels, secure bracket with
screws x6 (#8 x 16 Mush washer screws).
6 Side brackets and straps (Refer to F)
For Fisher & Paykel door panel sets,
align bracket and strap to the holes on
the side of the panel and secure with
screws x2 (M5 x 14 Mush Phillips SS).
For custom panels, secure bracket with
screws x2 (#8 x 16 Mush washer screws).
Repeat this process for all brackets
andstraps.
D
E
F
A
C