iiiliiii,I,I li,_,lliiIIIIIIIiiiiii IIIIIIIIIIIIiiiiiiiiiiiiii¸Iili11111111¸!Iiliii///i!li/:i:11!i'
Installation instructions
Dra_nhose
,_Carefu,ypu,thedra_nhoseoutfromthebackof
thewasherbypu,,ngthooxposedpartofthehoso
downwardsandoutwards. P=,hoso_ __
2 Toguidethedrainhoseoverthetub/sinkor through guide _[ _
standpipe the hose guide MUST be fitted to the _[ _T w'(20 ram)
drain hose. _! _ . _-_:_. , maximum
Important!
2 E
Topreventsiphoningthedrainhoseshouldnot _11__ I
extend more than _" (20 mm) from the end of the
guide,heightofthestandpipeortubJsin
shoutd be between 33 ½" to gS" (850- 2413 mm)o Flex hose _-_
The drain hose can be trimmed to tengtho guide _p_t _
3 Place the dram hose m the tub/sink or standp_peo Do
notfitthehosetoadrainspigot._rainagemustnot F_g.3F_ng_h_o'_ ho_g_o'_
beairtightinordertopreventsohoning.
= Importand
in mu#i-storey apartments or any upper floor instaflation, the washer shoutd be installed on a
f_oorthatise_uippedwithadrain.
o Check that the tub or standpipe is free from tint or other obstructions before operating the washer. ....
o in a basement installation do not exceed a stan@ipe height of 96" (2438 mm,L
nnlethoses
o Importand
New hose sets provided with the washer shaft be used to connect the washer to the water mains.
° Oidhosesetsshou,dnothere-used. [
1 Install hoses with the straight end (with filters) fitted
to the faucets (refer to FigA). '%_&_ i '_
2 nsta e bow ends onto c othes washer ( net va ves '_ _!_._, :
/ l\ ¢
are marked on the back of the washer H=hot, C=cold) _,'.">'_ _:]_][I
(refer to Fig.S). Ensure the hot valve is connected to _:_(' i: :_
the hot faucet and the cold valve is connected to the Fig 4 Faucetendof Fig _ 14!.asher:_:"_ndof
coldfaucet. _o_h_no'i _o_+,'bow_J_
Inlet hose replacement
We recommend the inlet hoses are changed every 5 ),'ears. Hoses should also be checked from
time to time and replaced if an)' wear, cuts, bulges, kinks or leaks are found. WARNING!: Failure to
do so ma)'resultina floodanddamageto pror_ert),.
To Next Page
Loading...
