599266B – CG913 Gas cooktop
NOTES
* The electrode should only spark for approximately 5 seconds before going into a
fault condition – red LED flashing slowly.
** Indicates there is not enough or too much gas flow at the burner.
*** Flame not normal – distorted, too big, yellow, lifting off burner
These repairs require gas qualifications.
YES
*Does the
problem
electrode
spark
now?
NO
Replace the ignition box
Replace the electrode
Replace the solenoid
Check the:
gas pressure
gas valve for grease blockage
gas pipes/connections for gas leak
or blockage.
YES
NO
YES
YES
Check the burner components are assembled
correctly, are clean and dry and not distorted.
Check the electrode:
is clean and dry
is not damaged
is not shorting inside the basepan area
lead is connected tightly at the ignition box.
Swap the electrode lead at the ignition box with one
that is working ok.
Check the:
ignition switch loom connections at
the ignition box
continuity, mounting and operation
of the ignition switch.
power supply up to the ignition
box
connections at the ignition box
continuity of the common wire in
the ignition switch loom.
Check the electrode:
is located correctly
is clean and dry
is not damaged.
YES **
Check the:
connections and wiring between the
ignition box and the solenoid
supply voltage is correct up to the
ignition box.
YES
Light another burner
Does it
function ok?
Replace the:
electrode
burner cap and spreader.
NO
YES
NO
YES*
NO
Burner not lighting properly
NO
Is the
electrode
sparking?
re the other
electrodes
sparking?
Does the burner
light with a
match or
manual
Is power
getting to the
solenoid?
NO
Check the:
burner components are assembled
correctly, are clean and dry and are not
distorted.
gas jet is the correct size for the gas type
and is not blocked
cookto
turned on?
Is the flame
behaving
normally***?
To Previous Page
Loading...
Need help?
General
