• Uncoil the power cord, remove and discard the plastic pin cover, and plug into wall socket and turn the power
on.
Installation test cycle
Your washer must be correctly installed before use. Check the machine’s installation and operation using the following
procedure:
1. Touch POWER to activate your washer.
2. Touch both the KEYLOCK and OPTIONS buttons at the same time, and hold for three seconds.
3. Touch START/PAUSE to start the installation test cycle.
4. The machine will beep to signal the end of the installation test cycle. Any faults will be displayed on the screen
(refer 'Troubleshooting' to identify faults). If you need further assistance, please contact a Fisher & Paykel
Customer Care Representative. Refer to 'Customer Care' for contact details.
If there are no faults found, the washer will automatically turn off at the end of the
installation test cycle.
Clothes washer safety
• This clothes washer is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
• The lid will be locked from the start of the cycle until the cycle is complete for safety reasons. To open the lid
during operation, you must touch START /PAUSE.
• Supervise children at all times to ensure they do not play with the washer.
• The only user-removable parts of the washer are the inlet hoses and dispenser funnels. No other parts are
designed to be removed by anyone other than a Fisher & Paykel Authorised Repairer.
If you are using an extension cord or a portable electrical outlet device (eg multi-socket
outlet box), ensure that it is positioned so that it does not come into contact with water or
moisture.
https://producthelp.fisherpaykel.com/nz/Wash/Top_Loaders/CleanSmart/WL1068P1/User_Guide_WL1068P1/02_Installation_…
Updated: Sat, 16 Nov 2019 03:22:08 GMT
Powered by
7
To Next Page
Loading...
Need help?
General
